🛠 Dynamic Display with M5Paper e-Ink Screen
M5Paper: IoT Development Kit with Tactile e-Ink Display · intermediaire · Configurez le pilote IT8951 pour afficher des données mises à jour sans clignotement.
- Hardware: M5Paper, USB-C cable, PC. 2. Setup: Install M5GFX library via Arduino IDE. 3. Config: Initialize M5.begin(). Set partial refresh mode to reduce latency. 4. Logic: Create a function reading sensor data. Use M5.Display.drawPixel or fillRect. Avoid full screen refreshes in loops to save battery. 5. Commands: Upload sketch. 6. Verification: Observe smooth updates. IT8951 handles gray levels automatically. 7. Next: Implement periodic full refresh to remove ghosting.
Other tutorials for this board
Code examples for this board
← Back to the board 🛠 All tutorials