PaperDIY Assembly Kit (M5Stack) · intermediaire · Guide étape par étape pour assembler le châssis et connecter les composants critiques sans endommager l'écran e-paper.
Materials: PaperDIY kit, Phillips screwdriver, tweezers, anti-static mat. 2. Preparation: Sort screws and connectors into separate compartments. Inspect the ED047TC1 e-paper flex cable for damage. 3. Chassis assembly: Gently insert the ESP32-S3 main board into the lower housing. Align USB-C port and physical buttons. Secure the board with provided M2 screws, tightening moderately to avoid PCB cracking. 4. Screen connection: Open the ZIF connector of the 8-bit parallel interface. Insert the flex cable, contacts facing down, until it stops. Carefully close the ZIF latch. Incorrect insertion may damage the 16-level grayscale display. 5. Battery and PMU: Connect the 140mAh battery to the dedicated JST connector near the M5PM1 chip. Ensure the cable does not obstruct the upper housing closure. 6. Closing: Place the e-paper screen into the upper frame. Clip the upper housing onto the bottom. Verify the PCB antenna is not pinched. 7. Verification: Press the Reset button. The screen should display a test pattern or remain neutral gray. If the screen stays white or shows artifacts, reopen the kit and reseat the flex cable. 8. Deepening: Test standby consumption via the M5PM1 chip to optimize battery life before intensive first use.