microDb

🛠 Flash Arduino firmware on PaperDIY

M5Stack PaperDIY Complete Kit · debutant · Installez l'environnement Arduino IDE et téléversez le premier croquis sur l'ESP32-S3.

  1. Software: Install Arduino IDE and add the Espressif ESP32 board manager via the official JSON link.
  2. Configuration: In the board manager, select 'M5Stack Paper'. Verify that the COM port is detected.
  3. Wiring: The kit is pre-assembled, no soldering required. Use 'Download' mode if necessary by holding the Reset button while connecting via USB.
  4. Command: Open a simple example (e.g., Hello World), select the correct COM port, then click 'Upload'.
  5. Verification: The screen must display the sketch text. In case of error, check USB drivers and the selected port.
  6. Deepening: Test WiFi connection by adding the WiFi.h library to scan networks.

Other tutorials for this board

← Back to the board 🛠 All tutorials